4 Replacement Procedures
4-36 Minnesota 10A/10AG Series Maintenance Manual
4.13 LCD Module
Removing the LCD Module
To remove the LCD module, first remove the display assembly, display mask, and FL
inverter board and then follow the steps below.
1. Disconnect all cables from the guides around the edge of the top chassis.
Figure 4-38 Removing the LCD Module
2. Remove four M2.5x4 screws securing the top chassis to the LCD module, and four
M2.5x5 screws securing the hinges to the LCD module.
○
A M2.5x5
○
B M2.5x4
Figure 4-39 Removing the LCD Module
To Next Page
Loading...
