4 Replacement Procedures
4-56 Minnesota 10A/10AG Series Maintenance Manual
4.23 Wireless Module
Removing the Wireless Module
To remove the wireless module, first remove the display assembly, keyboard, and top cover.
Then follow the steps below:
1. Remove the two M2x3 screws securing the wireless module to the system board.
Figure 4-66 Removing the wireless module screws
2. Remove the wireless module.
Figure 4-67 Removing the wireless module
Installing the Wireless Module
To install the wireless module, follow the steps below and refer to the figures in the preceding
section.
1. Seat the wireless module in the slot on the system board.
2. Replace the two M2x3 screws securing the wireless module to the system board.
To Next Page
Loading...
