4 Replacement Procedures
4-46 Minnesota 10A/10AG Series Maintenance Manual
4.18 Fingerprint Module
To remove the Fingerprint module, first remove the display assembly, keyboard, and top
cover. Then follow the steps below:
Removing the Fingerprint Module
1. Turn the top cover over. Remove four M2.0x2.5 screws securing the Fingerprint Module
Bracket to the back of the top cover. Follow the numbered order indicated on the bracket.
Figure 4-52 Removing the fingerprint module bracket screws
2. Remove the bracket.
Figure 4-53 Removing the fingerprint module bracket
To Next Page
Loading...
