Replacement Procedures
4.5 Wireless LAN card
Removing a Wireless LAN card
The following describes the procedure for removing a Wireless LAN card (See Figure 4-5).
1. Remove the following screw of wireless cover securing wireless LAN card cover
and remove it. And remove screw of wireless board
• 2.5.0 x 4.0B BIND screw x3
• Disconnect the wireless LAN antenna cable from the connectors on a
wireless LAN card,
• Remove the screw: 2.0 x 3.0 x2
2. Open the left and right latches holding a wireless LAN card and remove a wireless
LAN card from the connector on the system board.
Figure 4-5 Removing a wireless LAN card
Satellite A300 Maintenance Manual(960-Q08) 4-17