4 Replacement Procedures 4.7 Modem
4. Carefully lift the unit from its connector.
Figure 4-22 Removing the modem module
Installing the Modem
To install a modem, follow the steps below and refer to the figures in the preceding section.
1. Connect the modem connector on the system board to the modem module.
2. Fit the modem onto its connector and secure it with two black M2.5x3 screws.
3. Replace the M2.5x4 screw to fix the secondary HDD cover.
4-22
[CONFIDENTIAL]
Satellite P200
/ P205
Series Maintenance Manual
To Next Page
Loading...
