4.21 VGA PCB 4 Replacement Procedures
4.21 VGA PCB
Removing the VGA PCB
To remove the VGA PCB, first remove the battery pack, keyboard, display assembly, and top
cover, then follow the steps below:
1. Disconnect the VGA PCB wire cable from the system board.
Figure 4-61 Removing the VGA PCB FFC cable
2. Remove the M2x6 screw securing the VGA PCB. Then remove the two hexagonal VGA
screws from the left side of the computer.
Figure 4-62 Removing the VGA PCB screw and the hexagonal screws
Satellite P200
/ P205
Series Maintenance Manual
[CONFIDENTIAL]
4-53
To Next Page
Loading...
