Replacement Procedures
NOTE: Do not reuse the touch pad so that it can not be used after peeling off from the
computer. Be sure to stick a new touch pad.
When stickimg the touch pad, be careful not to get the bubbles under the touch
pad.
2. Stick and install the touch pad on the cover assembly.
3. Install the touch pad plate and secure it with the following screws.
• M2.5×3.0B SUPER THIN HEAD screw x7
4. Stick the insulator on the touch pad plate.
5. Connect the touch pad flat cable to the connector on the touch pad and stick the
glass tape on the connector.
4.14 Audio Board
The following describes for removing the cover assembly (See Figure 4-23).
Satellite U300 and Satellite Pro U300 Maintenance Manual (960-Q08)43
To Next Page
Loading...
