Replacement Procedures
4.16 USB Board
The following describes for removing the cover assembly (See Figure 4-25).
Removing USB board
1. Remove the USB cable from CN4 and USBCN1
2. Loose below screw from USB board
z M2.5x4.0 FLAT BIND screw x1
Figure 4-25 Removing the USB board
Installing the USB Board
1. Put USB board in correct location and fix below screw
z M2.5x4.0 FLAT BIND screw x1
2. Connect the USB cable between CN4 and USBCN1
Satellite U300 and Satellite Pro U300 Maintenance Manual (960-Q08) 44
To Next Page
Loading...
