Replacement Procedures
Remove the Fingerprint
1. Pull out the fingerprint cable from connect CN14
2. Loose below screws from fingerprint board and take it out top case
z M2.5x4.0 FLAT BIND screw x2
M2.5x4.0
Figure 4-24 Removing the Fingerprint
Installing the Fingerprint
1. Turn over top case and put fingerprint in correct location
2. Fix below screws and connect the fingerprint cable CN14
z M2.5x4.0 FLAT BIND screw x2
Satellite U300 and Satellite Pro U300 Maintenance Manual (960-Q08)43
To Next Page
Loading...
