Replacement Procedures
4.18 CPU
Removing the CPU heat sink
The following describes the procedure for removing the CPU heat sink (See Figure 4-27 ).
1. Disconnect the Heat sink cable from the connector CN24 on the system board
2. Remove the following screws securing the heat sink holder along 1 to 3.
• M2.5×4.0 BIND screw x3
NOTE: When removing the heat sink holder, be sure to remove the screws in the reverse
order of the number marked on the holder.
3. Remove the CPU heat sink.
4
M2.5 x 4.0 BIND
2
5 3
1
CPU heat sink
CN20
Figure 4-27 Removing the CPU heat sink
Satellite U300 and Satellite Pro U300 Maintenance Manual (960-Q08) 4-47
To Next Page
Loading...
