17
SETTING UP YOUR TV
English
ATV Manual Tuning
The television can be tuned-in manually using ATV Manual
Tuning. For example, you might use the feature if the television
cannot be connected to a media recorder/decoder with a SCART
lead or when you want to tune-in a station on another System.
Use
C and c to move across the screen and select any of the
ATV Manual Tuning options. Then use
B or b to adjust the
settings.
1 Position
The number to be pressed on the remote control to tune
the channel.
2 System
Specific to certain areas.
3 Colour System
Factory set to Auto, should only be changed if problems
are experienced, i.e. NTSC input from external source.
4 Skip
Set Skip to On (
8) or Off (() for the selected channel.
See page 18.
5 Signal Class
The channel classification.
6 Channel
The channel number on which a station is being
broadcast.
7 Search
Search up and down for a signal.
8 Manual Fine Tuning
Only used if interference/weak signal is experienced. See
page 71.
9 Station
Station identification. Use the
B or b and C or c buttons
to enter up to seven characters.
To allocate a position on the television for a decoder and
media recorder: turn the decoder on, insert a pre-recorded
film in the media recorder, press PLAY, and then manually
tune.
a In the System Setup menu, press b to highlight ATV
Manual Tuning and press OK.
b Use B or b to highlight the desired position. We
suggest Pos. 0 for a media recorder.
c Press OK to select. If the channel chosen for the media
recorder is set to skip, Skip should be removed before
storing.
d Press c to select System and use B or b to change if
required.
e Then press c to select Search.
f Press B or b to begin the search. The search symbol
will flash.
Tuning
To Next Page
Loading...
