55
CONTROLS AND FEATURES
English
You can set your preferences for recording or for scheduling
recording.
To set the recording time for One Touch Recording
a Press MENU /C c to highlight Setup icon.
b Press B or b to highlight Preferences icon and press
OK.
c Press B or b to select Recording Setup and press
OK.
d Press B or b to select One Touch Recording Time
and press OK.
e Press C or c to select the recording time.
You can set the Programme End Time in 30-minute
increments in the range of 30 minutes to 360 minutes.
To set the padding time for programmed
recording start time and end time.
a Press B or b to select Start Padding Time on the
Recording Setup screen.
b Press C or c to select a time.
You can select from None, 1 minute, 3 minutes, 5
minutes and 10 minutes. Recording will start at the
selected number of minutes prior to the recording
start time.
c Press B or b to select End Padding Time from the
Recording Setup menu.
d Press C or c to select a time.
You can select from None, 1 minute, 3 minutes, 5
minutes and 10 minutes.
Recording will end at the recording end time plus the
selected number of minutes.
Setting USB HDD Energy-Saving Mode
a Press B or b to select Recording Devices from the
Recording Setup screen and press OK.
b Press B or b to select Device Energy-Saving Mode.
c Press C or c to select Normal or Energy Saving.
NOTE:
• When set to Energy Saving, it may take a while for the USB
HDD to function.
• When set to Energy Saving, depending on the type of USB
HDD, the USB HDD indicator lamp may not indicate standby
status even when in standby status.
To change the name of the USB HDD
a Press B or b to select Recording Devices from the
Recording Setup screen and press OK.
b Press B or b to select Device List and press OK. The
Device List screen will appear.
c Press the GREEN button.
Edit the desired name by using the software
keyboard. (See page 47) The maximum number of
characters is 25.
NOTE: If multiple USB HDD appear on the Device List screen
in Step 2, press
B or b to select the USB HDD whose name
you want to change.
To perform a USB HDD operation test
a Press the YELLOW button on the Device List screen.
USB HDD operation test will start.
Wait until the test ends.
NOTE: The results of the device test are only a guide.
The device may not function as shown in the results.
Recording Setup
To Next Page
Loading...
Need help?
General