Installation
Installation
LVMU Installation Guide 03/06 9
3. Press Enter. UAdmin synchs up to the modem. A message reading Connection
established appears briefly on the screen and the Main Menu displays.
Step 7: Configure the LVMU
To configure the LVMU, you may need to use the following menu selections available from the
Tools option on the Main Menu:
• Toshiba Plug and Play
• Telephone System Configuration
• Stratagy System Configuration
For a complete description of the standard menu selections and field descriptions, see the
Stratagy Installation & Maintenance manual on OPGONLINE.
To access Tools Option
1. Press
Alt+t.
2. Type the password (the default password is
Stratagy) and press Enter.
Toshiba Plug and Play
The LVMU is pre-installed for the Strata CIX100 processors. If you need to change this selection to
a different Strata CIX telephone system, change it now using this selection.
Note If you only want to change the PBX type, do not use this function. Instead, set the
pbx_type parameter in the Stratagy System Configuration screen.
Selecting this function:
• Changes all the settings to the new Toshiba telephone system default values.
• Deletes any User ID mailbox customizations.
• Installs the LVMU default mailboxes.
Note Existing messages and mailbox greetings are not deleted when Plug and Play is selected.
For example, if Mailbox 200 has messages and greetings and Toshiba Plug and Play for
Strata CIX is run, then Mailbox 200 retains the messages and greetings from the previous
database.
Change Toshiba Plug and Play Option
1. From the Tools menu, press 5.
2. From the Toshiba Plug and Play screen, enter the number of the selection.
The LVMU utility automatically defines the telephone system dial codes and tone patterns,
system integration patterns and default mailboxes for the specific telephone system.
Note Strata CTX28 is not supported.
3. When the process is complete, press any key to reboot. The DOS prompt displays.
4. To continue, re-enter UAdmin.The Main Menu displays with the new telephone system
designation.
5. Press Alt+t to access the Tools submenu.