Maintenance
Restore Utility
20 LVMU Installation Guide 03/06
Restore Utility
CAUTION! Because of possible errors that can be induced through the telephone network,
Toshiba advises that you perform the Restore Utility on site.
The LVMU Restore Utility is used to restore previously backed up names, greetings and/or
database from the Admin PC to the LVMU.
Restore the Database(s)/Names/Greetings
CAUTION! LVMU Voice Processing is suspended during the restore procedure. Any
existing connection is broken.
1. From the Tools menu, press
2.
2. From the Restore screen
(shown at right), enter the
selection number. A second
screen displays requesting
the source directory.
3. The directory defaults to
C:\UADMIN21\BACKUP on the Admin PC. If you have the file(s)
backed up to a different directory, type over the default. Press
Enter.
Notes
l Restoring files from the Admin PC’s floppy disk drive is not supported.
l Be sure to enter the complete path, including the drive letter.
4. (Optional) If you entered selection 2 “Restore Names & Greetings” in Step 2, you are asked to
enter a beginning and ending mailbox number. Press
Enter after each entry
Note Leaving both fields blank defines all mailboxes.
...or if you entered selection 3 “Restore Database, Names & Greetings” in Step 2, press
Enter in the mailbox number fields to leave them blank.
Important! This selection restores the entire database and all names and greetings. You cannot
restore selective mailboxes.
Before the restore starts, UAdmin
calculates the time the process takes
and displays a status message (sample
shown at right).
5. Press Y to restore the files
...or
N to cancel the
procedure.
6. Press
Y to continue.
CAUTION! If the LVMU is not rebooted, all ports remain in an off-hook condition.