Toshiba Strata DK 16 - Handset Hanger; Removing the Telephone Base; Wall Mounting Base Rotation

6-3
INSTALLATION-STATION APPARATUS
SECTION 100-816-206
MARCH 1993
FIGURE 6-1
REMOVING THE TELEPHONE BASE
FIGURE 6-2
HANDSET HANGER
FIGURE 6-3
WALL MOUNTING BASE ROTATION
HANDSET
HANGER
PLASTIC
TAB
HANDSET
HANGER
2.42 Mount digital and electronic telephones in
accordance with the following steps:
NOTES:
1. Digital telephones equipped with Inte-
grated Data Interface Units (PDIU-DIs or
PDIU-DI2s) cannot be wall mounted.
2. Electronic and older digital telephones
equipped with an HHEU1 can be wall
mounted. 2000-series Digital Telephones
with headsets can only be wall mounted
with an HHEU2.
1) Loosen the captive screws, and remove the
telephone base (Figure 6-1).
2) Using a suitable cutter, remove the handset
hanger from the base (Figure 6-1). Insert the
handset hanger in the slot provided on the
front of the telephone (Figure 6-2). The hanger
fits in the notch on the handset cradle.
3) Rotate the telephone base 180 degrees and
secure it to the telephone with its four captive
screws (Figure 6-3).