REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-50-
To store data, press CR.
Continue returning to step 3 until all data is recorded for this
program.
To exit this program, press # # CR.
PROGRAM 48
STATION TOLL RESTRICTION CLASSIFICATION
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE PROG
P
Enter the Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 48
P48
Enter Program Number 48
3 P48 00Refer to the System Record Sheet and enter the required port
number.
Example: Port 00, enter 0 0.
Press CR.
4 Press # key. The system will display the present data as a
two-digit code: The first digit designates digit free or digit restrict.
The second digit is the station restriction code. Refer to the
System Record Sheet and change if required.
P48 00# 13
5 To Exit Program/Store Data P48 00# 13
P48 ##
P
A)
B)
C)
To store data, press CR.
To exit this program, press # # CR.
PROGRAM 50-1
LCR PARAMETERS
ACTIONSTEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 50
P50
Enter Program Number 50.
3 P50 1 01 NEnter 1. Refer to the System Record Sheet and enter the required
button/LED number.
Example: Button 01, enter 0 1.
Press CR.
4 Refer to the System Record Sheet and change button/LED status,
if required.
Press SPACE to move to next button/LED.
P50 1 01 N
02 N
5 To Exit Program/Store Data P50 1 01 N
02 N
P50 ##
P
A)
B)
To Next Page
Loading...
