Toshiba Strata DK 16 - Page 303

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-53-
TABLE RM-BC
PROGRAM 50-6
LCR DIAL ZERO TIMEOUT
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 50
P50
Enter Program Number 50
3 P50 6 06 10
Press CR.
4 P50 6 06 10
P50 ##
P
Exit Program/Store Data
A)
B)
To store data, press CR.
To exit this program, press # # CR.
Enter the number 6
The system will display the present dial zero timeout.
Refer to the System Record Sheet and change if required.
Example: 10, enter 1 0.
TABLE RM-BD
PROGRAM 51
LCR AREA CODES
ACTIONSTEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 51
P51
Enter Program Number 51
3 P51 1
Press CR.
6 Exit Program/Store Data
A)
B)
C)
To store data, press CR.
Continue returning to step 3 until all data has been
entered for this program.
To exit this program, press # # CR.
P51 12
212
or
P51 ##
P
4
Enter 2, 3, or 4 SPACE
Refer to the System Record Sheet and enter the required
route plan number (1 ~ 8).
Example: Route plan 1, enter 1.
P51
P51
• 2
• 3
• 4 SPACE
— To add area codes to table.
— To delete area codes from table.
— to display area codes in table,
continue to press SPACE to display more codes.
Press CR to exit display.
2, 3 or 4
<— CODES
5
Enter codes or
*
and
press SPACE after each code entry.
P51
Plan No.