Toshiba Strata DK 16 - Page 316

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-66-
TABLE RM-BS
STATION/CO LINE STATUS CHECK
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE TESTEnter the Test Mode
At the >MODE prompt, enter T E S T CR.
2 T SEKT XX IDLE ON-HOOK
T
To Check Station Line Status
3 To Check CO Line Status
Enter S E K T X X (X X = port number).
Possible status: Idle on-hook, idle off-hook, busy on-hook,
busy off-hook.
4 To Exit the Test Mode
At the T prompt, enter Q U I T CR.
T SCOYY – BUSY
TEnter S C O Y Y (Y Y = CO line number).
Possible status: Idle, busy.
T QUIT
> MODE
IMPORTANT!
To prevent service interference, station line status must be
idle on-hook before initiating a test from that station.
TABLE RM-BT
GENERAL STATION ACCESS AND BUTTON ACTIVATION
ACTIONSTEP DISPLAY/PRINTOUT
1
>MODE TEST
T
Enter the Test Mode
At the >MODE prompt, enter T E S T CR.
2 T TKXX KYY
T
To Activate A Button
Enter T K X X K Y Y CR.
XX = Port number and YY = button number.
NOTE: Button numbers begin at 01.
3 TTKXX F
T
To Activate A Function Button
Enter T K X X F CR F = function button designator
SPKR
HOLD
CONF
MIC
S
H
C
M
4 TTKXX K01 AAA
T
To Access A CO Line (via CO Access Code) and Dial Out
Enter T K X X K 0 1 A A A CR.
AAA = 1, 2, or 3-digit CO line access code and
= telephone number.
5 TTKXX KYY
T
To Access A CO Line (via CO Line Button) and Dial Out
Enter T K X X K Y Y CR.
YY = CO line number.
6 To Exit the Test Mode
At T prompt, enter Q U I T CR.
F = S, H, C, M
Telephone Number