Toshiba Strata DK - Program Toshiba; Station Features

Interface Implementation
The FCN [number] and LINE [number] labels represent the key
sequence on the handset mapped to the corresponding key on the
desk set.
The handset function menu default settings are shown in the table
below; these may be changed as described above in Function Menu
Programming. Some of these functions (Mute, Redial, Forward, etc.)
are activated by softkeys or
FCN menu options on the SpectraLink
6000 and SpectraLink 8020/8030 Wireless Telephones.
FCN + 1
MUTE
FCN + 2
CNF/XFR
FCN + 3
REDIAL
FCN + 4
MSG
FCN + 5
FWD
FCN + 6
SPEED
FCN + 7
PICK
FCN + 8
PAGE
FCN + 9
EXIT MENUS
Program Toshiba
Station features
Perform the necessary system programming using a 20-button LCD
digital or electronic telephone connected to Port 005. All or a group of
handsets can be programmed at one time by entering a range of ports.
• Use Program 30 and Program 31 to designate Station Class of
Service features for the handset. If the handset has no speaker be
sure to set these features as follows:
Speakerphone Enabled – Off
Mic on at Start of Call - Off
Handsfree Disabled
Paging Zone Off
• Use Program 32 to designate Automatic Preference for the
handset, if desired.
• Use Program 33 to designate the "Hunt to" port number or range
of numbers for the handset, if desired.
• Use Program 40 to designate CO Line Access, if necessary. This
may need to be done if the ports assigned to the handsets are new
(i.e. not previously initialized).
1725-36145-001_D.doc
15