T2150 Series
Installing the Optional Memory Module
To install an optional memory module in the T2150 series, follow the steps below and refer to
figure 4-6.
1. Insert the memory module, connectors first, into the computer’s connectors.
Note the notch at the corner of the module. This notch should be on the right as
you insert the module (figure 4-6).
Figure 4-6 Inserting the memory module
2. The module is held up by springs in the computer’s socket. Gently push the
module into place until two latches close over each side.
3. Fit the socket cover’s latches into place and seat the cover (figure 4-5).
4. Secure the two M2x4 silver screws (figure 4-4).
5. Install the battery pack as described in section 4.2.
6. The T2150 series automatically configures all additional memory as extended
memory.
To Next Page
Loading...
