T2150 Series
4.9 CD-ROM Drive
Removing the CD-ROM Drive
To remove the T2150 series CD-ROM drive, follow the steps below and refer to figures 4-19
and 4-20.
1. Turn off the power. Disconnect the AC power cord and all external cables con-
nected to the T2150 series.
2. Remove the battery pack, keyboard, hard disk drive, optional PCMCIA card,
optional memory module, top cover, display assembly, and AC PS unit as de-
scribed in sections 4.2 through 4.8.
3. Disconnect the CD-ROM drive cover and the CD-ROM cable from PJ8 on the
system board and remove three M2.5x6 screws on the CD-ROM bracket (figure
4-19).
Figure 4-19 Removing the CD-ROM drive with bracket
To Next Page
Loading...
