T4900CT
4. Remove the tape, if necessary, then disconnect the display cable from PJ3 and the
FL inverter cable from PJ2 on the upper system board (figure 4-22).
5. Remove the M2.5x6 screw securing the display ground cable (figure 4-22).
Figure 4-22 Removing the display, FL, and ground cables
6. Turn the computer around and remove the two M2.5x6 silver screws on the back
of the computer which secure the display assembly (figure 4-23).
Figure 4-23 Removing the screws (back of computer) securing the display assembly
To Next Page
Loading...
