T4900CT
3.18 Hard Disk Format
This command executes hard disk formatting. There are two types of hard-disk formatting:
❑ Low-level (physical) formatting
❑ MS-DOS (logical) formatting
This hard disk format function performs a low-level format of the hard disk and executes the
following hard disk formats and check:
1. All track FORMAT
2. Good track FORMAT
3. Bad track FORMAT
4. Bad track CHECK
CAUTION: The contents of the hard disk will be erased when this program is executed.
Before executing the function, transfer the contents of the hard disk onto a floppy
disk(s). This can be done with the Toshiba MS-DOS BACKUP command. See the
Toshiba MS-DOS manual for details.
3.18.1 Function Description
1. All track FORMAT
This option performs a low-level format of all the tracks on the hard disk as shown
in Table 3-6 below:
NOTE: Before executing the all track format option, check for bad tracks
using the Bad Track CHECK option or display a list of bad tracks on the
HDD.
Table 3-6 Hard disk formatting sequence
810 MB
DVAA-2810
Sector sequences 1
Cylinders 0 to 1,570
Heads 0 to 15
Sectors 1 to 63
Sector length (bps) 512
To Next Page
Loading...
