T4900CT
4.10 Display Assembly
Removing the Display Assembly
To remove the T4900CT’s display assembly, follow the steps below and refer to figures 4-21
through 4-24.
1. Turn off the power to the T4900CT. Disconnect the AC adapter, power cord, and
all external cables connected to the T4900CT.
2. Remove the battery pack, optional memory card, optional PCMCIA card, HDD
pack, and top cover as described in sections 4.2 through 4.6.
3. Remove the tape securing the panel close switch cable, then disconnect it from
PJ6 on the upper system board (figure 4-21).
Figure 4-21 Removing the panel close switch cable
To Next Page
Loading...
