English - 17 -
UART 0
Select ASCII/HEX protocol for UART 0. Default value is ASCII. There is no need to
restart the Display after selection in order to work with the protocols correctly. If the
the Display is booted up.
Also note that HEX protocol will work with the baud rate value 19200 for UART0
UART 1
Select ASCII/HEX protocol for UART 1. Default value is HEX. There is no need to
restart the Display after selection in order to work with the protocols correctly. If the
the Display is booted up.
Also note that HEX protocol will work with the baud rate value 9600 for UART1
Power Up Mode
Last State, Always On and Standby
options are available.
Quick Standy
If this feature is enabled the Display can be turned on again
commands if it is turned off through it. Press Left or Right button to enable or disable
the feature. Enable if you wish to use the scheduler function.
Power on Delay
Sets a delay value at power on. This value can be set from 0 to 2000 ms in steps of 100
ms. The Display will turn on after the set delay time is expired.
Auto Launch
CMS(Start url)Open Browser(Open Browser
initial page) and Disabled options are available.
Boot Up Picture
Mode
Off the last set picture
mode will be used at power on.
HDMI1 Wake Up
Enabled
monitoring video content alone.
inactive and can not be set as Enabled.
Clone to USB
Clone from USB
Internal USB
operations
connected.
Copy app cache
from USB
Copies app cache data from a connected USB device to the unit.
Note: This feature may not be available depending on the model of your unit.
USB Information
Press OK to open the USB information menu screen. Current Total space and Free
space informations of the connected USB device will be displayed. You can also format
the connected USB device using the Format Disk
option in this menu (FAT32 format
only).
USB operations
Highlight and press OK to perform USB operations. See separate USB operations
command list for available functions available on your monitor.
USB Option
Set as Off to disable the USB ports on the Display. You can also set this option as 5V
to provide 5 volts power over USB. In this case it will still not be available to browse the
USB content via Media Browser feature of the Display.
OPS Settings
Press OK to open the OPS Settings menu screen.
Three sub-menu options are
available.
OPS Information: Displays read-only information about the OPS unit, if supported.
OPS Status:
Displays whether the OPS module is on or off. Allows the change of
status via soft PSON signal (0.5s)
Powerdown: Turns the OPS off via hard PSON signal (5s)
Note: This menu will not be available if OPS is not supported or not connected to the unit.
To Next Page
Loading...
