Toshiba Tecra 8200 Series - RTC Battery Removal; RTC Battery Removal Steps; System Board Removal; System Board Removal Steps

SYSTEM BOARD REMOVAL
1. Remove one M2.5x6 black screw securing the
select Bay cover.
2. Remove the HDD connector cover.
FIELD REPLACEABLE UNIT DOCUMENTATION
Tecra
TM
8200 Series
TOSHIBA
Tough Enough for Today’s World.
3. Remove four M2.5x4 brass screws and
one M2.5x4 hexagonal screw securing the
system board.
4. Lift out the system board.
1. Unfold the PC card eject buttons and remove the
PC card slot cover.
PC card slot cover
Eject buttons
RTC BATTERY REMOVAL
1. Disconnect the RTC battery cable from PJ201 on the
system board.
2. Unlatch the plastic shield and lift out the RTC battery.
PJ201
Plastic
shield
RTC battery
cable
RTC
battery
HDD connector cover
M2.5x6
black
screw
Select Bay cover
System board
M2.5x4 brass screws
M2.5x4 Hex screw