Toshiba Tecra 8200 Series - CPU Removal Steps; Modem Board Removal; Modem Board Removal Steps

.
TOSHIBA
Tough Enough for Today’s World.
FIELD REPLACEABLE UNIT DOCUMENTATION
Tecra
TM
8200 Series
CPU lock
LOCK
CPU REMOVAL
CPU lock
OPEN
1. Rotate the CPU lock 180 degrees clockwise, to the
OPEN position, and lift the CPU out of the socket.
1. Remove one M2.5x4 brass screw securing the Wireless
LAN antenna relay board and three M2x4 silver screws
securing the modem relay board.
2. Lift up the left side of the modem relay board to disconnect
from PJ610 on the system board and remove the modem
relay board and RJ11/RJ45 jack upward.
3. Disconnect the LAN cable from PJ150 on the system board.
Modem
relay board
MODEM BOARD REMOVAL
M2x4 silver screws
RJ11/RJ45
jack
M2.5x4
brass
screw
Wireless LAN antenna relay board
4. Remove two M2x5 silver screws securing the MDC
(modem daughter card).
5. Lift up the back of the MDC to disconnect it from
the modem relay board.
6. Disconnect the modem cable from the MDC.
M2x5 silver screws
Modem cable
MDC