Toshiba Tecra 8200 Series - HDD Removal Steps; Keyboard Removal

HDD REMOVAL
5. Remove four M3x4 flat head brass screws securing
the HDD to the bracket and lift the drive out of the
bracket.
6. Unplug the HDD connector from the drive.
KEYBOARD REMOVAL
1. Open the display panel.
2. Using the case separator, unlatch the keyboard holder
at the top of the keyboard.
M3x4 flat head brass screws
3. Remove two M2.5x2.8 black screws securing the
keyboard.
4. Lift out the keyboard and set it as shown above.
5. Disconnect the keyboard cable from PJ580 on the
system board.
HDD connector
TOSHIBA
Tough Enough for Today’s World.
FIELD REPLACEABLE UNIT DOCUMENTATION
Tecra
TM
8200 Series
4. Unfold the plastic tab and pull to remove the HDD
from the bay.
Plastic Tab
HDD pack
Keyboard holder
Keyboard
Latch
Case separator
M2.5x2.8 black screws
HDD
HDD
bracket