MEMORY MODULE REMOVAL WIRELESS LAN REMOVAL
1. Turn the computer upside down.
2. Remove two M2.5x4 black flat head screws and
remove the memory cover.
3. Spread the memory clips outward and pull the memory
module out of the connector on a 45 degree angle.
HDD REMOVAL
1. Turn the computer upside down.
2. Remove one M2.5x4 black flat head screws
securing HDD cover
3. Push up the raised nubs to remove the HDD cover.
M2.5x4 black
flat head screws
HDD cover
TOSHIBA
Tough Enough for Today’s World.
FIELD REPLACEABLE UNIT DOCUMENTATION
Tecra
TM
8200 Series
Memory
module
Memory clips
Memory
cover
M2.5x4 black
flat head screws
Black coax cable
Mini-PCI
connector
clips
White coax cable
Wireless
LAN card
1. Turn the computer upside down.
2. Remove two M2.5x4 security torx screws securing
the Wireless LAN cover and lift out the cover.
3. Disconnect the Black and White coax from PJ12 and
PJ13.
4. Spread the Mini-PCI connector clips and pull the
Wireless LAN card out of the connector about
45 degree angle.
Mini PCI cover
M2.5x4 security torx screw
To Next Page
Loading...
