Toshiba Tecra 8200 Series - Speakers and Microphone Removal; Speakers and Microphone Removal Steps; Sound Board Removal; Sound Board Removal Steps

SOUND BOARD REMOVAL
COOLING MODULE REMOVAL
1. Lift the strip of glass tape securing the microphone and
speaker cables.
2. Disconnect the speaker cable from PJ961 and the
microphone cable from PJ964 on the sound board.
3. Remove the cables and lift out the speaker assemblies.
1. Disconnect the sound cable from PJ407 on the
system board.
2. Remove two M2.5x4 screws securing the sound
board.
3. Lift out the sound board assembly.
4. Disconnect the sound cable from PJ1 on the
sound board.
1. Disconnect the fan cable from PJ202 on the system
board.
2. Remove four M2x10 brass screws securing the cooling
module.
3. Lift out the cooling module.
CPU REMOVAL
1. Peel off the thermal conductor.
TOSHIBA
Tough Enough for Today’s World.
FIELD REPLACEABLE UNIT DOCUMENTATION
Tecra
TM
8200 Series
SPEAKERS & MICROPHONE REMOVAL
Tape
Right
speaker
Microphone
Rubber holders
Left speaker
Microphone
cable
PJ4
Left/Right
speaker
cable
PJ3
PJ407
Sound cable
PJ1
M2.5x4
brass
screws
Sound board
Fan cable
PJ202
Cooling
module
M2x10 brass screws
Thermal
conductor
CPU
lock