7-10 User’s Manual
HW Setup
Ending the BIOS Setup Program
Save the changes and end the program.
1. Press the End Key.
The “Are you sure? (Y/N) The changes you made will
cause the system to reboot.” message is displayed.
2. Press the Y key.
The configured settings are saved and the BIOS setup program ends.
The computer may reboot depending on the settings that were
modified.
Ending the BIOS Setup Program Halfway
The configuration settings can be terminated halfway without saving any of
the changes made.
1. Press the Esc key.
The “Exit without saving? (Y/N)” message is displayed.
2. Press the Y key.
The BIOS setup program will end.
Execute-Disable Bit Capability
This setting enables or disables the Execute-Disable Bit function.
The Execute-Disable Bit Capability setting is available in SYSTEM SETUP
(1/2).
Security controller
The security controller settings are available in SYSTEM SETUP (2/2).
TPM
This setting enables or disables the security controller known as TPM
(Trusted Platform Module).
Available Make the Execute-Disable Bit Capability usable
(Available).
Not Available Disable the Execute-Disable Bit Capability (Not
Available) (Default).
System configuration changes other than changes to this setting should be
made in Windows using TOSHIBA HW Setup, TOSHIBA Password
Utility, TOSHIBA Power Saver, Device Manager, etc.
Enabled Enables the TPM.
Disabled Disables the TPM (Default).
To Next Page
Loading...
