User’s Manual 8-17
Optional Devices
Advanced Port Replicator IIl
In addition to the ports available on the computer, the Advanced Port
Replicator lll provides Parallel port. The Advanced Port Replicator connects
directly to the docking interface on the underside of the computer. The AC
adaptor connects the Advanced Port Replicator to a power source.
The following ports and accessories are available on the Advanced Port
Replicator III.
■ RJ45 LAN jack
■ RJ11 Modem jack
■ External monitor port
■ Parallel port (This port can be used only when Advanced Port
Replicator lll is connected).
■ Serial port (This port is not supported by the computer).
■ PS/2 mouse port (This port is not supported by the computer).
■ PS/2 keyboard port (This port is not supported by the computer).
■ DC IN 15V jack
■ Security lock slot
■ Audio line-in, line-out jacks (This port can be used only when Advanced
Port Replicator lll is connected).
■ Universal Serial Bus 2.0 port (four)
■ i.LINK (IEEE 1394) port
■ DVI port
The computer must be configured properly before connecting to a LAN.
Logging onto a LAN using the computer’s default settings could cause a
malfunction in LAN operation. Check with your LAN administrator
regarding set-up procedures
.
■ You must connect the AC adaptor before you connect to an Advanced
Port Replicator III.
■ When an Advanced Port Replicator III is connected to the computer,
you can not use the following computer’s ports: DC IN 15V jack,
Modem jack, LAN jack, External monitor port, Video-out jack, i.LINK
(IEEE 1394) port.
■ The TECRA M4 does not support the PS/2 port and Serial port on the
Advanced Port Replicator III.
To Next Page
Loading...
