User’s Manual 4-13
Operating Basics
Changing to the laptop mode
To change the Tablet mode to the laptop mode, follow the instructions
below.
1. Press the Display latch and raise the display to the upright position
carefully.
2. Rotate the display counter-clockwise slowly.
3. Turn the display latch toward you for the next closing of the display.
Using the USB floppy disk drive
USB floppy disk drive connects to the computer’s USB port. It
accommodates 1.44-megabyte or 720-kilobyte floppy disks. Refer to
Chapter 2, The Grand Tour, for more information.
Connecting USB floppy disk drive
To connect the drive, plug the floppy disk drive’s USB connector into a
computer’s USB port. Refer to Figure 4-15.
Figure 4-15 Connecting the USB floppy disk drive
You can set the orientation of the desktop screen just after rotating the
display from [Start]-[All Programs]-[TOSHIBA]-[Tablet PC]-[TOSHIBA
Rotation Utility]
Make sure the connector is right side up and properly aligned with the
socket. Do not try to force the connection, doing so can damage the
connecting pins.
USB
connector
USB port
If you connect the USB floppy disk drive after turning on the computer, it
will take about 10 seconds for the computer to recognize the drive. Do not
disconnect and reconnect before 10 seconds has elapsed.
To Next Page
Loading...
