User’s Manual 4-3
Operating Basics
Replacing the cap
The AccuPoint cap is an expendable item that should be replaced after
prolonged use. One spare AccuPoint cap is supplied with the computer.
1. To remove the AccuPoint cap, firmly pinch the cap and pull it straight
up.
Figure 4-2 Removing the AccuPoint cap
2. Position a new cap on the peg and press it into place.
Using the Tablet PC Pen and Reserve Pen
You can use the Tablet PC Pen to execute actions and enter data. Hold the
Tablet PC Pen in a natural position and tap, press or trace on the screen
lightly. Before you begin using the TOSHIBA TECRA M4 for the first time,
you will need to calibrate the Tablet PC Pen. Refer to the Pointing Device
section in Chapter 9, Troubleshooting.
Some computers in the series are equipped with a Reserve Pen.
Figure 4-3 The Tablet PC Pen (the left) and Reserve Pen (the right)
The peg is square, so be careful to align the cap’s square hole with the
peg.
Eraser button
Pen button
Pen point
Pen button
Pen point
To Next Page
Loading...
