User’s Manual 9-13
Troubleshooting
Pointing Device
If you are using a USB mouse, also refer to the USB section in this chapter
and to your mouse documentation.
TOSHIBA Tablet PC Pen
Touch Pad/AccuPoint
Problem Procedure
On-screen pointer
does not respond to
Tablet PC Pen
operation
The system might be busy. If the pointer is
shaped as an hourglass, wait for it to resume its
normal shape and try again to move it.
The Tablet PC Pen might be set unable to use.
Press Fn + F9 keys to change Pen setting to
enabled.
Tablet PC Pen and
on-screen pointer do
not move in the same
manner
Adjust the coordinate axis in the following
procedure.
1. Open the Control Panel and click Printer
and other Hardware.
2. Click the Tablet and Pen setting.
3. Select screen orientation with "Calibrate" in
"Setting" tab.
4. Click "Calibrate" button.
5. Click the cross in "Calibrate the screen" and
click "OK".
Unable input from
Tablet PC Pen
Adjust the setting in the following procedure.
1. Open the Control Panel and click Printer
and other Hardware.
2. Click the Tablet and Pen setting.
3. Adjust setting of each item of "Pen options"
tab and click "OK".
Problem Procedure
Either the Touch Pad
or the AccuPoint does
not work.
Check the Device Select settings. Click start,
click Control Panel, click Printers and Other
Hardware and select Mouse icon. Open the
Mouse Properties and click Dual Pointing
Device tab. Then click the Detail Setting button
and click the Device Select tab.
Check that the Touch Pad is not selected.
Pressing Fn + F9 to enables Pointing Device.
To Next Page
Loading...
