4.5 HDD 4 Replacement Procedures
4. Place the HDD assembly on a flat surface, and remove the following screws.
• M3×4S FLAT HEAD screw ×4
5. Separate the HDD and HDD Holder.
CAUTION: Do not apply pressure to the top or bottom of the HDD.
HDD
HDD Holder
M3×4S FLAT HEAD
M3×4S FLAT HEAD
Figure 4-7 Separating the HDD and HDD holder
TECRA M5 Maintenance Manual (960-542) [CONFIDENTIAL] 4-15
To Next Page
Loading...
