4 Replacement Procedures 4.22 PC card slot
4.22 PC card slot
Removing the PC card slot
To remove the PC card slot, follow the steps below and refer to Figure 4-41.
1. Turn up the insulator on the back.
2. Remove the following screws and PC card slot.
• M2×3S S-THIN HEAD screw ×2
• M2×8S S-THIN HEAD screw ×2
PC card slot
M2x3S S-THIN HEAD
M2x8S S-THIN HEAD
Figure 4-41 Removing the PC card slot
Installing the PC card slot
To install the PC card slot, follow the steps below and refer to Figure 4-41.
1. Turn up the insulator on the back. .
2. Install the PC card slot and secure it with the following screws.
• M2×3S S-THIN HEAD screw ×2
• M2×8S S-THIN HEAD screw ×2
4-58 [CONFIDENTIAL] TECRA M5 Maintenance Manual (960-542)
To Next Page
Loading...
