4 Replacement Procedures 4.19 Fan
4.19 Fan
Removing the Fan
To remove the fan, follow the steps below and refer to Figure 4-35.
1. Remove the following screws securing the fan.
• M2.5×4B FLAT HEAD screw ×2
2. Peel off the glass tape and disconnect the fan cable from the connector CN8771 on
the system board.
3. Remove the fan from the slot.
M2.5×4B FLAT HEAD
Fan
Fan cable
CN8771
M2.5
4B FLAT HEAD
Glass tape
Figure4-35 Removing the fan
4-52 [CONFIDENTIAL] TECRA M5 Maintenance Manual (960-542)
To Next Page
Loading...
