Toshiba Tecra M5 - Slim Select Bay Module

4.6 Slim select bay module 4 Replacement Procedures
4.6 Slim select bay module
Removing the Slim select bay module
To remove the slim select bay module, follow the steps below and refer to Figure 4-8 and 4-9.
CAUTION: The slim select bay module can become hot with use. Be careful when
removing the module.
1. Remove the following screw securing the latch to unlatch the slim select bay and
drive the removed screw into the screw hole.
• M2.5×4B FLAT HEAD screw ×1
2. While sliding the latch in the direction of the arrow in the figure below, remove the
slim select bay module (from connector on the system board).
M2.5×4B FLAT HEAD
Slim select bay module
Latch
Screw hole
Figure 4-8 Removing the slim select bay module
TECRA M5 Maintenance Manual (960-542) [CONFIDENTIAL] 4-17