Toshiba Tecra M5 - System Board;Hdd Cable;DC-IN Jack

4 Replacement Procedures 4.20 System board/HDD cable/DC-IN jack
4 Replacement Procedures
4.20 System board/HDD cable/DC-IN jack
Removing the System board/HDD cable/DC-IN jack
To remove the system board/HDD cable/DC-IN jack, follow the steps below and refer to
Figure 4-36 to 4-39.
1. Remove the HDD cable holder A from the slot of the base assembly.
2. Remove HDD cable from the HDD cable holder B.
3. Peel off the glass tape.
System board
HDD cable
holder A
HDD cable
HDD cable
holder B
Glass tape
Figure 4-36 Removing the system board/HDD cable/DC-IN jack (1)
4-54 [CONFIDENTIAL] TECRA M5 Maintenance Manual (960-542)