4 Replacement Procedures 4.7 Memory module
4.7 Memory module
Removing the Memory module
To remove the memory module, make sure the computer is in boot mode and powered off,
follow the steps below and refer to Figure 4-10 to 4-11.
1. Loosen the screw (with an e-ring) and remove the memory cover while releasing
latches.
Memory cover
Screw (with an
e-ring)
Figure 4-10 Removing the memory slot cover
2. Press two latches outward and remove the memory module.
Latch
Latch
Memory module
(expansion)
Memory module
Slot B
Slot A
Figure 4-11 Removing the memory module
4-20 [CONFIDENTIAL] TECRA M5 Maintenance Manual (960-542)
To Next Page
Loading...
