4 Replacement Procedures 4.8 Keyboard
5. Lift the keyboard upward a little and turn it face down on the palm rest.
NOTE: The bottom of the key board is stuck on the middle frame with double-sided tapes
at following two points.
.
Double-sided tape
6. Remove the following screws and keyboard support plate.
• M2.5×16B FLAT HEAD screw ×1
• M2.5×4B FLAT HEAD screw ×1
M2.5×16B FLAT HEAD
M2.5×4B FLAT HEAD
Keyboard support plate
Figure 4-14 Removing the keyboard support plate
4-24 [CONFIDENTIAL] TECRA M5 Maintenance Manual (960-542)
To Next Page
Loading...
