4.12 Wireless LAN card 4 Replacement Procedures
2. Disconnect the wireless LAN antenna cables (black and white) from the wireless
LAN card using an antenna coaxial cable disconnector.
3. Remove the following screw securing the wireless LAN card.
• M2×4S BIND screw ×1
4. Disconnect the wireless LAN card from the connector CN 2600 on the system board.
Be careful not to damage the connector.
Wireless LAN card
M2x4S BIND
CN2600
Figure 4-23 Removing the wireless LAN card
TECRA M5 Maintenance Manual (960-542) [CONFIDENTIAL] 4-37
To Next Page
Loading...
