4.28 Hinge 4 Replacement Procedures
7. Remove the LCD cable holder B while releasing the latch.
8. Remove the following screw and earth plate.
• M2×4B S-THIN HEAD screw ×1
9. Remove the following screw securing the hinge (left).
• M2.5×4S Tapping screw ×1
10. Remove the hinge (left) while sliding and turning it.
11. Pull out the LCD cable from the hole.
M2.5×4S Tapping
M2.×4B S-THIN HEAD
Earth plate
Hinge (left)
LCD cable
LCD cable holder B
Figure 4-52 Removing the hinge
TECRA M5 Maintenance Manual (960-542) [CONFIDENTIAL] 4-75
To Next Page
Loading...
