1-14
3-9. Intake Fan
Step Figure Explanation
1 Remove filter from bottom plate.
2 Remove 3 screws (3 x 8).
Screw: type [M-4]
3 Remove 3 sheets of tape.
Remove 2 screws (3 x 14).
Screw: type [M-3]
4 The fan block is separated into 3 pieces as shown.
5 Remove 2 sheets of tape.
Remove 2 screws (3 x 14).
Screw: type [M-3]
Tape
To Next Page
Loading...
