The Default setting menu
This menu shows placement status and other settings.
Default setting 1 menu
Item
Description
Auto keystone Always corrects keystone distortion automatically. On Off
No signal
power off
Sets the time to wait for the power to be turned off after the last operation is
made with no input signal.
Off (not turned off)
30 min.
Auto input
search
Sets whether the input with signals is only selected or not. On Off
Beep Beeps when operation is made. On Off
Power on Sets whether to turn on the power when the ON/STANDBY button is pressed
(Manual), or when the power cord is plugged in (Auto).
Manual Auto
Lamp power
Sets the lamp power.
Low
Standard
Detailed description
[Auto input search]
[On]: Automatically searches the signals that can
be projected, and switches input from the
connected device that outputs the video signals
each time the INPUT button is pressed. Input
from a connected device that outputs no video
signals is skipped.
[Off]: Displays the Input select menu.
Toggle with
buttons and press
button.
(The input without signals can be also selected.)
Note
In normal operation, set [Auto input search] to [On].
Set to [Off] when you want to select the input source from Input select menu, or if
the image does not appear properly.
[Power on]
If [Power on] is set to [Auto] and there is a power outage, the projector will come on
once power is restored.
[Lamp power]
When [Lamp power] is set to [Low], the screen becomes a little darker, but the cooling
fan noise gets quieter.
•
Computer 1
Y/PB/PR 1
Computer 2
Y/PB/PR 2
Video
S-video
USB memory
Input select
/ shows whether signal is
input or not.
Input select menu
Default setting 2 menu
Item
Description
Projection
mode
Sets projection mode in accordance with Placement Style.
(Standard)
(Rear)
(Ceiling)
(Rear ceiling)
Fan mode Sets the cooling fan speed. Standard
High
Remote control When 2 projectors are used and controlled by the remote control respectively,
this menu sets the code for the projector and the remote control.
[ or : Enter setting] [
: Select from 1, 2
] [ : Confirm]
[
:Select OK to end
]
Press [Cancel] to return.
Key lock Lock the control panel buttons.
[ or : Enter setting] [
: Select On/Off
] [ : Confirm]
[
:Select OK to end
]
Press [Cancel] to return.
Closed Caption Closed Caption settings.
Press and switch with and . Off/ CC1/ CC2/CC3/CC4/T1/T2/T3/T4
Reset all
Press . (The password and user logo are not reset.)
Resets all adjustments and settings to their factory settings. Yes
No
Password
Password setting
Press . Password registration/Password setting
Detailed description
[Fan mode]
Setting [Fan mode] to [High] increases the cooling fan speed. (The cooling fan noise
increases.) Set this option to use the projector at high altitude (over 1,500 meters
above sea level).
Do not set Fan mode to [High] when using the projector at a lower altitude.
[Remote control]
Sets a remote control code from 2 types. You can set each code respectively for up to
2 projectors. The factory setting is [
1].
To switch codes, set the same code for the projector and the remote control.
A remote control code is applied after the setting is done.
You cannot operate the remote control if the codes of the projector and the remote
control do not match.
Remote control code setting for remote control
Set the same remote control code switch as the projector.
•
•
Using the menus (Continued)
To Next Page
Loading...
