• [Interval]
You can set the display interval of time (in seconds or minutes) for slide shows to be
played automatically.
Note
It may take time to display slide show with some files.
• [Display effect]
When playing a slide show, the projector can give various display effects or transitions
to each slide being displayed.
The transitions available are listed below:
• None
Displays each slide with no display effects.
• Wipe
Displays the next slide with a gradual upward (Wipe ↑), downward (Wipe ↓), to the left
(Wipe ←), or to the right (Wipe →), over the current slide.
• Dissolve
Displays the next slide gradually in a certain fixed block pattern over the current slide.
• Cover
Displays the next slide as sliding upward (Cover ↑), downward (Cover ↓), to the left
(Cover ←), or to the right (Cover →), over the current slide.
• [Play icon]
The slideshow icon can be displayed.
• Standard
The projector handles the slideshow icon as follows depending on the “On/Off” setting
of Icon on the projector’s menu.
Icon On: The projector displays the icon upon the start of playing a slide show and
turns it off after a few seconds.
Icon Off: The projector does not display the icon.
• Continuous
The projector keeps the icon displayed during the slide show.
• [Thumbnail display]
Select the form of a thumbnail list.
All: Displays a thumbnail preview of JPEG files, and if any JPEG files exist in the
folder displays the leading thumbnail image.
File: Displays only a thumbnail image of JPEG files. The thumbnail image of the JPEG
files in the folder is not displayed.
Off: Displays an icon without displaying thumbnail preview.
• [Unplug device]
Run when unplugging a USB memory, a USB memory card reader/writer or a digital
camera and the like.
Displaying Information (Status display)
This displays information about the input signal, lamp use time, etc.
“Yes”: displayed, “No”: not displayed
Item Description
Computer
Y/PB/PR Video S-video
USB
memory
Input Input source name Yes Yes Yes Yes Yes
Mode name RGB input mode
[Note 1]
Yes No No No No
Resolution Resolution (in dots) Yes No No No No
Frequency Sync frequency Yes No No No No
Sync Sync signal polarity
[Note 2]
Yes No No No No
Signal format Y/PB/PR signal format No Yes No No No
Video mode Color method of video signal No No Yes Yes No
Lamp time Time of lamp use
[Note 3]
Yes Yes Yes Yes Yes
Lamp reset count The count for lamp replacement Yes Yes Yes Yes Yes
Total time The total time that this projector
is used.
Yes Yes Yes Yes Yes
Version Firmware version
[Note 4]
Yes Yes Yes Yes Yes
Notes
1: The mode of supported RGB signals
is shown.
2: Sync signal polarity shown as P (positive) or N (negative) for [H/V].
3: Displays [
Lamp time] as an estimated measure of when the lamp should be replaced.
(Cannot be used as a counter of guaranteed lamp time.) When the displayed time
approaches 2,000 hours, consult with a dealer about getting replacement lamp
TLPLW21 (sold separately).
4: [
Version] shows the version of the projector’s internal control program. This version will
be requested for customer service purposes.
Note
The displayed information will not be refreshed if the status changes. To refresh the
information, dismiss the display, then display it again.
•
Using the menus (Continued)
To Next Page
Loading...
