List of supported signals (RGB signals)
This projector supports the following RGB signals. Note, however, that depending on the
computer model, the screen may show flicker or streaking. Please adjust the projector if
this happens.
Resolution Mode
Refresh rate
(Hz)
H-frequency
(kHz)
Clock
(MHz)
720 x 400 720x400_85 85.039 37.927 35.500
640 x 480 VGA_60 59.940 31.469 25.175
VGA_72 72.809 37.861 31.500
VGA_75 75.000 37.500 31.500
VGA_85 85.008 43.269 36.000
800 x 600 SVGA_56 56.250 35.156 36.000
SVGA_60 60.317 37.879 40.000
SVGA_72 72.188
48.077 50.000
SVGA_75 75.000 46.875 49.500
SVGA_85 85.061 53.674 56.250
832 x 624
MAC16" 74.550 49.725 57.283
1024 x 768
XGA_60 60.004 48.363 65.000
XGA_70 70.069 56.476 75.000
XGA_75 75.029 60.023 78.750
XGA_85 84.997 68.667 94.500
MAC19" 74.700 60.134 79.857
1152 x 864
SXGA1_75 75.000 67.500 108.000
1280 x 960
QuadVGA_60 60.000 60.000 108.000
QuadVGA_85 85.002 85.938 148.500
1280 x 1024 SXGA3_60 60.020 63.981
108.000
SXGA3_75 75.025
79.976 135.000
SXGA3_85 85.024
91.146 157.500
1400 x 1050 SXGA+ 59.978 65.317 121.750
1600 x 1200
UXGA_60 60.000 75.000 162.000
UXGA_65 65.000 81.250 175.500
UXGA_70 70.000 87.500 189.000
UXGA_75 75.000 93.750 202.500
UXGA_85 85.000 106.250 229.500
Note
Signals whose resolution exceeds the native resolution (1024 × 768 dots) will be
compressed. For this reason, some information may be lost, and/or image quality may
be affected.
•
List of supported signals (Component signals)
Signal format fh(kHz) fv(Hz)
480i(525i)@60Hz 15.73
59.94
480p(525p)@60Hz 31.47
59.94
576i(625i)@50Hz 15.63
50.00
576p(625p)@50Hz 31.25
50.00
720p(750p)@60Hz
45.00 60.00
720p(750p)@50Hz 37.50
50.00
1080i(1125i)@60Hz 33.75
60.00
1080i(1125i)@50Hz 28.13
50.00
1080p(1125p)@60Hz
67.50 60.00
1080p(1125p)@50Hz 56.25
50.00
List of supported signals (Video, S-Video signals)
Video mode fh(kHz) fv(Hz) fsc(MHz)
NTSC 15.73 60 3.58
PAL 15.63 50 4.43
SECAM 15.63 50 4.25 or 4.41
PAL-M 15.73 60 3.58
PAL-N 15.63 50 3.58
PAL-60 15.73 60 4.43
NTSC4.43 15.73
60 4.43
Pin assignment of COMPUTER 1 IN, COMPUTER 2 IN and
MONITOR terminals
Pin No.
Pin description
During RGB input
During Y/PB/PR input
1 Video signal (R)
Color difference signal (PR)
2 Video signal (G)
Luminance signal (Y)
3 Video signal (B)
Color difference signal (PB)
4 GND
*
5 GND
*
6 GND(R) GND(PR)
7 GND(G) GND(Y)
8 GND(B) GND(PB)
9 N.C
*
10 GND
*
11 GND
*
12
N.C
*
13
Horizontal sync signal
*
14
Vertical sync signal
*
15 N.C
*
*
Do not connect anything.
Input Signal
RGB input
RGB signals: 0.7 V (p-p) 75
Ω
Horizontal sync signal: TTL level (Pos/neg polarity)
Vertical sync signal: TTL level (Pos/neg polarity)
Y/PB/PR input
Y signal: 1.0 V (p-p) 75
Ω
PB/PR signals: 0.7 V (p-p) 75
Ω
•
•
Mini D sub 15 Pin connector
To Next Page
Loading...
