END USER SETTINGS – MODE SCREEN
DEFINITION DEPENDENCIES FUNCTION
The “Mode Screen” is used to
allow the end user to see and
change the currently selected
mode. The center of this screen
displays the Off Mode Button, the
Heat Mode Button, the Cool Mode
Button, the Auto Mode Button, and
the Emergency Heat Mode Button.
The horizontal yellow Mode
Selected Bar is always shown
above the mode that has been
selected by the end user.
Some modes may not be available
based on the Indoor Equipment Type
or the Outdoor Equipment Type
selections. An example of a system
without any Cooling or Aux Heating
equipment selected is shown in the
right most screen shown above. The
Cool Mode Button, the Auto Mode
Button, and the Emergency Heat
Mode Button in this screen (and
associated text) is “greyed” to
indicate that these options are not
available and the buttons cannot be
selected.
Changing from one mode to another mode will not
affect operation of the thermostat until the newly
selected Mode Button has been selected for at
least 10 seconds. Changing from one mode to
another (e.g. Heat mode to Cool mode) will first
require that the thermostat first satisfy any
Minimum ON Timer requirements and then will
restart the Minimum OFF Timer that will be
required to expire before equipment will be turned
on in the new mode. Going from any Heating or
Cooling Mode to Off Mode will immediately shut
off an equipment that is active (after the 10
second mode button requirement is satisfied).
9
Scroll
Mode*Selected*Bar
Available
on APP
To Next Page
Loading...
