21
20
Flushing
●
The toilet can be flushed by pushing the flush button on the remote controller.
There are 2 settings for flushing water. The remote controlled setting and the auto setting.
Remote Controlled Flushing
1
Push the flush button on the
remote controller.
The toilet bowl is flushed.
1.6 Gallons per Flush (6 LPF)
If the remote controller batteries need replacing
●
Use the flush button located on the main unit controls to flush the toilet.
Push the flush button on the
main unit controls.
When finished, move away
from the toilet (more than
one foot).
After 3 seconds the toilet
will automatically flush.
(light goes out)
Motion detection
sensor
●
When the motion detection sensor does not detect
motion near the toilet, the sensor light located on the
main unit control goes out.
2
●
The default setting for the Auto flush is ON.
●
Even while seated, the sensor may fail to detect the user and "Auto Flush" depending on the user's
sitting position.
Automatic Flushing
●
The toilet will automatically flush when the user moves away from the toilet. (This function prevents the
toilet bowl from being left unflushed.)
[ ] indicates Auto Flush is "On".
Auto Flush ON/OFF button
Back of the Remote Controller
Confirm that the Auto Flush display on the back of the remote controller is "On".
● You must sit on the toilet seat for at least 6
seconds in order to activate the automatic
flush function.
1
The toilet bowl flush button cannot be pushed repeatedly. Wait 10 seconds before pushing the button again.
The toilet bowl is flushed.
1.6 Gallons per Flush (6 LPF)
1.6 Gallons per Flush (6 LPF)
When sitting on the toilet
seat
Operation
2
To Next Page
Loading...
Need help?
General
